This is the easiest part and anyone can do this. There is a process below and all you have to do is follow them. So you will not be electrocuted. It can be done in a few minutes. Just make sure that it fits perfectly and you will not do anything that will mess it up. Some people does like to replace them all the time.

That is why they choose to buy something that is of good quality. Having a good one will refrain them from buying always and keep changing. Replacement hard drive can only last for several minutes to do it. But ensure that they are not working anymore. Check if it is time to change for a new one.

Here are the steps that you should apply. This is very easy and simplified so anyone will not have a hard time. Always choose something that will benefit you and could save time. When you buy for a new one, make sure that it should be of the same type and is compatible.

Start in backing up your files. You never know what could happen. This is for your own sake. Especially those files that are very important to you. There is a tendency that you could not recover them without moving and making a copy of them. You could transfer it to another hard drive. Like USB that can accommodates a lot of space.

After you do it, you can now shut down the PC. Do it before you would do anything else. Always practice safety procedures. And never risk your life because you only have the one. And please avoid problems if possible. This is your precautionary measure. And never touch the inner component if you have not turn off everything.

Open the case. Disregard the monitor this time. And just work with the CPU. When you see the one at the back of it, open them. You might need screw drivers of different size. Get your tools to do it. Unscrew them all so it will be open. Never do anything like you force them to remove. It will be remove if you check all the screw carefully.

After opening it, go to the location where the old one is located. Be extra careful in doing that. You might touch the other parts and would mess them up. You have to check if it is screwed inside. Otherwise you cannot remove them right away. Unscrew them and see to it that the other parts will not be damage. You will only remove something that needs to be replaced.

Once finished taking all the screw, you can now takes out the old one. Hold them with your hand and support your hand at the bottom. Make sure not to touch the surface. Placed them on the side. And get ready with the new one to put inside. Get the jumpers. You could use it when installing the new purchase.

Put the new one inside. Just repeat the procedures above. Just be sure you should not forget everything. And screw everything. So they will not be move and the disk must not be damage. If done, now check if it is successful. And see if the old software is still there. Otherwise you can reinstall them back. And see the performance.